FAA Router Rollout Paused as Senators Press for Safety Testing
Summary
The FAA paused installation of Juniper routers while investigators examine the cause of a November 13 network disruption that led to a nationwide ground stop. Thirteen Democratic senators urged the agency to resume deployments only after further operational testing, independent review, and verification of backup and rollback procedures.Key Facts
- The November 13 disruption led to a nationwide ground stop that lasted more than four hours and ended at about 8:15 p.m.
- The ground stop was the longest nationwide one in 25 years.
- Network instability affected communications and radar feeds at 17 of the FAA’s 22 Air Route Traffic Control Centers, along with several terminal radar facilities.
- Investigators have focused on equipment associated with FAA facilities in El Dorado, Arkansas, and Amarillo, Texas.
- The FAA said it had paused installation of the Juniper routers.
- Thirteen Democratic senators asked the FAA to halt further deployments until the equipment passes additional testing and independent validation.
- The senators said contractor L3Harris information showed plans to convert 3,648 routers; about 400 had been installed, with 69 operating.
- The disruption caused widespread flight delays and cancellations as airlines worked to recover.
This is a fact-based summary from The Actual News. Click below to read the complete story directly from the original source.